Editing Universal asynchronous receiver-transmitter (section)

===Transmitter===
Transmission operation is simpler as the timing does not have to be determined from the line state, nor is it bound to any fixed timing intervals. As soon as the sending system deposits a character in the shift register (after completion of the previous character), the UART generates a start bit, shifts the required number of data bits out to the line, generates and sends the parity bit (if used), and sends the stop bits. Since full-duplex operation requires characters to be sent and received at the same time, UARTs use two different shift registers for transmitted and received characters. High-performance UARTs could contain a transmit FIFO (first in, first out) buffer to allow a [[CPU]] or DMA controller to deposit multiple characters in a burst into the FIFO rather than have to deposit one character at a time into the shift register. Since transmission of a single or multiple characters may take a long time relative to CPU speeds, a UART maintains a flag showing busy status so that the host system knows if there is at least one character in the transmit buffer or shift register; "ready for next character(s)" may also be signaled with an interrupt.